The Process of 3D
Questions?
Questions that some may have since this is just the begining of me learning along the way of 3D printing. If you have any question make sure to follow me on IG: @sakiace or maybe I'll make a discord ;)
The Setup
Depending on the model I usually send my drawing of my character to get done 3D, but I create the Vase part in blender. I then use Cura to make the size I want of the model to be printed and then save it to my SD, plug that into the 3D printer & heat up my printer to then print. Some models can take up to 4 days to finish printing.
The After
The after steps of printing can be tricky since every step usually takes a few days to be completed. There are chemicals which I am being exposed to with using glazing spot putty, primer spray, dust of print as I sand and the after gloss spray so I take my time.
Also sometimes when I print I leave it printing overnight & the printing can get stuck in which some cases I would have to restart & that can take me back a few days.
